HEIDENHAIN TNC 407 (243 020) Technical Manual - Manual (Page 433)

01.98
TNC 407/TNC 415/TNC 425 3 List of machine parameters 5-31
Machine
parameter Function and input Change
via Reaction Page
MP6362 Feed rate reduction if stylus of the TM 110 is
deflected away from its path
Entry: 0 or 1
0 =
Feed rate reduction not active
1 = Feed rate reduction active
4-191
MP6390 Target window for contour-line end point
Entry: 0.1000 to 4.0000 [mm] 4-191
3.9.3 Tool calibration with TT 110
Machine
parameter Function and input Change
via Reaction Page
MP6500 Tool Calibration with TT 110
Entry: 0 or 1
0 =
Cycles for tool calibration inhibited
1 = Cycles for tool calibration not inhibited
4-194
MP6505 Probing direction for tool measurement
Entry: 0 to 3
0 =
Positive probing direction in the angle
reference axis (0°axis)
1 = Positive probing direction in the +90°-axis
2 = Negative probing direction in the angle
reference axis (0° axis)
3 = Negative probing direction in the +90°-axis
4-194
MP6507 Calculation of the probing feed rate
Entry: 0 to 2
0 =
Calculation of the probing feed rate with
constant tolerance
1 = Calculation of the probing feed rate with
variable tolerance
2 = Constant probing feed rate
4-194
MP6510 Max. permissible measuring error for tool
measurement with rotating tool
Entry: 0.002 to 0.999 [mm] 4-194
MP6520 Probing feed rate for tool measurement with non-
rotating tool
Entry: 10 to 3000 [mm/min] 4-194
MP6530 Distance from tool lower edge to probe contract
upper edge for tool radius measurement
Entry: 0.001 to 99.9999 [mm] 4-194
MP6531 Diameter or edge length of TT 110 probe contact
Entry: 0.001 to 99 999.9999 [mm] 4-194
MP6540 Safety zone around the probe contact TT 110 for
pre-positioning
Entry: 0.001 to 99 999.9999 [mm] 4-194