beautypg.com

Mp5200 mp5200.0 mp5200.1 mp5200.2, Plc run cn 123, Mp5201 mp5201.0 mp5201.1 mp5201.2 – HEIDENHAIN TNC 407 (243 020) Technical Manual User Manual

Page 672: Mp5202 mp5202.0 mp5202.1 mp5202.2, Mp5203 mp5203.0 mp5203.1 mp5203.2, Mp5204 mp5204.0 mp5204.1 mp5204.2, Mp5205 mp5205.0 mp5205.1 mp5205.2, Mp5206 mp5206.0 mp5206.1 mp5206.2, Mp5207, Mp5207.0 mp5207.1 mp5207.2

background image


01.98

TNC 407/TNC 415/TNC 425

2 TNC data interfaces

8-25

For the control characters for the data transmission protocols ( , , ,
, ), any other ASCII characters can be chosen using the following machine
parameters (for table of ASCII characters, see Appendix). If these machine parameters are loaded
with a nought, the standard settings given in brackets are active (as for FE1 and FE2 operation).

MP5200
MP5200.0
MP5200.1
MP5200.2

Control character for Start of Text (STX)
In mode EXT 1
In mode EXT 2
In mode EXT 3 (PLC)
Input range: 0 to 127

MP5201
MP5201.0
MP5201.1
MP5201.2

Control character for End of Text (ETX)
In mode EXT 1
In mode EXT 2
In mode EXT 3 (PLC)
Input range: 0 to 127

MP5206
MP5206.0
MP5206.1
MP5206.2

Control character for Start of Command Block (SOH)
In mode EXT 1
In mode EXT 2
In mode EXT 3 (PLC)
Input range: 0 to 127

MP5207
MP5207.0
MP5207.1
MP5207.2

Control character for End of Command Block (ETB)
In mode EXT 1
In mode EXT 2
In mode EXT 3 (PLC)
Input range: 0 to 127

MP5208
MP5208.0
MP5208.1
MP5208.2

Control character for "Transfer O.K." (ACK)
In mode EXT 1
In mode EXT 2
In mode EXT 3 (PLC)
Input range: 0 to 127

MP5209
MP5209.0
MP5209.1
MP5209.2

Control character for "Transfer Defective" (NAK)
In mode EXT 1
In mode EXT 2
In mode EXT 3 (PLC)
Input range: 0 to 127

MP5210
MP5210.0
MP5210.1
MP5210.2

Control character for "End of Transmission (EOT)
In mode EXT 1
In mode EXT 2
In mode EXT 3 (PLC)
Input range: 0 to 127

When selecting ASCII characters, it must be ensured that the control characters are not arbitrarily
mixed and that no figures or letters which occur in the transferred text are used.
Example: The control character for Start of Text (MP5200.x) must not be assigned to ,
otherwise transmission will stop when software handshaking is set on the peripheral.