HEIDENHAIN TNC 407 (243 020) Technical Manual - Manual (Page 439)

01.98
TNC 407/TNC 415/TNC 425 3 List of machine parameters 5-37
Machine
parameter Function and input Change
via Reaction Page
MP7267 Items in pocket table
Entry: 0 to 99
0 = No display
1 to 99 = Position in pocket table
MP7267.0 Tool number (T)
MP7267.1 Special tool (ST)
MP7267.2 Fixed pocket (F)
MP7267.3 Locked pocket (L)
MP7267.4 PLC status (PLC)
CN 123 4-226
MP7270 Display of the feed rates in manual operating
modes (Manual operation, Electronic handwheel)
Entry: 0 or 1
0 = Display of the axis feed-rate only when an
axis-direction key is pressed (axis-specific
feed from MP1020.X)
1 = Display of the axis feed-rate before operating
an axis-direction key (smallest value
from MP1020.X for all axes)
PLC RUN
CN 123 4-138
MP7280 Decimal sign
Entry: 0 or 1
0 = Decimal comma
1 = Decimal point PLC RUN
CN 123 4-154
MP7285 Calculation of the tool length in the position display
of the tool axis
Entry: 0 or 1
0 = tool length ignored
1 = tool length taken into account
PLC RUN
CN 123 4-134
MP7290 Position display step
Entry: 0 to 6
0 = 0.1 mm or 0.1
°
1 = 0.05 mm or 0.05
°
2 = 0.01 mm or 0.01
°
3 = 0.005 mm or 0.005
°
4 = 0.001 mm or 0.001
°
5 = 0.0005 mm or 0.0005
°
TNC 415 B only
6 = 0.0001 mm or 0.0001
°
TNC 415 B only
MP7290.0 = X axis
MP 7290.1 = Y axis
MP 7290.2 = Z axis
MP 7290.3 = 4th axis
MP 7290.4
= 5th axis
PLC RUN
CN 123 4-134