HEIDENHAIN TNC 407 (243 020) Technical Manual - Manual (Page 351)

4-226
TNC 407/TNC 415/TNC 425 15 Tool changer 01.98
15.1.1 Special Tools
In the pocket table the "ST" field can be used to define tools as special tools. If these are oversize
tools that are too big for one pocket in the tool magazine, then pockets must be reserved on either
side of that pocket. In the pocket table these pockets are locked by the "L" field.
P7 P8 P9 P6 P5 P10
Variable pocket coding can be restricted by the "F" field (fixed pocket). For special tools, variable
pocket coding can also be restricted with marker M2601. If marker M2601 is set then all special
tools are returned to their original pocket despite "variable pocket coding" being selected. This
function can also be defined for specific normal tools in the "F" field.
Marker Function Set Reset
M2601 Special tool to original pocket despite variable
pocket coding
PLC PLC
In software types 243 05, 259 91, 259 96, 259 97, 243 07 and 243 02 the special tools are identified
by "S" in the tool table. The number of reserved pockets has been defined in machine parameter
MP7264. MP7264 is no longer available.
MP7264 Number of reserved pockets next to special tool
Entry: 0 to 3