HEIDENHAIN TNC 407 (243 020) Technical Manual - Manual (Page 689)

8-42
TNC 407/TNC 415/TNC 425 2 TNC data interfaces 01.98
Output selected file
The following protocol is followed:
Peripheral unit
.
.
.
Transmission path TNC
1st line of file BCC
Last line of file BCC
.
.
.
Name BCC
.
.
.
The program name may contain up to 16 characters.
Output all files
The files are output in order, as in section 4.1.2 "Outputting a selected file". Control characters
are sent to the peripheral device between files.
Output file with confirmation
In this mode, a question is asked before each file output in order to determine whether or not the
file is to be output. After each file, control characters and are sent, as in section 4.1.3
"Outputting all files". If output of a file is not desired, the TNC immediately offers the next file in the
directory for output.