HEIDENHAIN TNC 407 (243 020) Technical Manual - Manual (Page 434)

5-32
TNC 407/TNC 415/TNC 425 3 List of machine parameters 01.98
Machine
parameter Function and input Change
via Reaction Page
MP6550 Rapid traverse in the probing cycle for TT 110
Entry: 10 to 10 000 [mm/min] 4-194
MP6560 M function for spindle orientation for measuring
individual teeth
Entry: –0 to 88
–1
= Spindle orientation directly via NC
0 = Function inactive (error message)
1 to 88 = Number of the M function for spindle
orientation via PLC
4-194
MP6570 Max. permissible surface cutting speed at the tool
edge
Entry: 1.0000 to 120.0000 [m/min] 4-194
MP6580 Coordinates of the TT 110 stylus centre referenced
to the machine datum
Entry: –99 999.9999 to 99 999.9999 [mm]
MP6580.0 Axis X
MP6580.1 Axis Y
MP6580.2 Axis Z
4-194
3.10 Tapping
Machine
parameter Function and input Change
via Reaction Page
MP7110.0 Minimum feed-override when tapping
Entry: 0 to 150 [%]
PLC RUN 4-114
MP7110.1 Maximum feed-override when tapping
Entry: 0 to 150 [%]
PLC RUN 4-114
MP7120.0 Dwell-time for change of direction of spindle
rotation in "tapping" cycle
Entry: 0 to 65.535 [s]
PLC RUN 4-114
MP7120.1 Advanced switch time of spindle for "tapping" cycle
with coded output
Entry: 0 to 65.535 [s]
PLC RUN 4-116
MP7120.2 Spindle run-on time after reaching total hole depth
Entry: 0 to 65.535 [s] PLC RUN 4-114
MP7130 Spindle run-in characteristic
Entry: 0.001 to 10 [°/min]
(matching MP1520)
PLC EDIT 4-118
MP7140 Transient response of spindle on acceleration
Entry: 0.001 to 1
(matching MP1530)
PLC EDIT 4-118