HEIDENHAIN TNC 407 (243 020) Technical Manual User Manual
Page 258

MP 7310
Graphics display
Entry: %xxxxx
Bit 0
Switch-over display
in three planes
0 = German preferred
1 = U.S. preferred
Bit 1
Rotate coordinate system in
machining plane by +90
°
0 = no rotation
1 = coordinate system rotated through +90
°
Bit 2
BLK form after datum shift
0 = BLK form will not shift
1 = BLK form will shift
Bit 3
Show cursor position in
0 = not shown
3-plane display
1 = cursor position shown
This manual is related to the following products: