4 tapping – HEIDENHAIN TNC 407 (243 020) Technical Manual User Manual
Page 237

4.4 Tapping
There are two tapping cycles available in the control:
•
tapping with floating tap holder and
•
rigid tapping.
Tapping with floating tap holder is possible for both analogue and BCD-coded spindle-speed output.
Rigid tapping is only possible for analogue spindle-speed output.
The tapping cycle is defined in the NC-program and can be called with CYCL CALL (M03). Tapping is
adjusted to the dynamic behaviour of the machine by machine parameters.
This manual is related to the following products: