HEIDENHAIN TNC 407 (243 020) Technical Manual - Manual (Page 350)

01.98
TNC 407/TNC 415/TNC 425 15 Tool changer 4-225
MP7224.0 Disable file types
Bit 2 Tool tables 0 = not disabled
1= disabled
MP7224.1 Protect file types
Bit 2 Tool tables 0 = not protected
1= protected
MP7260 Number of tools in tool table
Entry: 0 to 254
MP7261 Number of pockets in pocket table
Entry: 0 to 254
MP7266 Elements of the tool table
Entry: 0 to 99
0 = no display
1 to 99 = position in tool table
MP7266.0 Tool name (NAME)
MP7266.1 Tool length (L)
MP7266.2 Tool radius (R)
MP7266.3 Tool radius 2 (R2)
MP7266.4 Oversize tool length (DL)
MP7266.5 Oversize tool radius (DR)
MP7266.6 Oversize tool radius 2 (DR2)
MP7266.7 Tool locked? (TL)
MP7266.8 Replacement tool (RT)
MP7266.9 TIME 1
MP7266.10 TIME 2
MP7266.11 CURRENT TIME
MP7266.12 Comment on the tool (DOC)
MP7266.13 Number of tool cutting edges
MP7266.14 Wear tolerance for tool length
MP7266.15 Wear tolerance for tool radius (RTOL)
MP7266.16 Cutting direction of the tool (DIRECT)
MP7266.17 PLC status (PLC)
MP7266.18 Tool length offset (TT: L-OFFS)
MP7266.19 Tool radius offset (TT: R-OFFS)
MP7266.20 Breakage tolerance for tool length (LBREAK)
MP7266.21 Breakage tolerance for tool radius (RBREAK)
MP7267 Elements of pocket table
Entry: 0 to 99
0 = no display
1 to 99 = position in pocket table
MP7267.0 Tool number (T)
MP7267.1 Special tool (ST)
MP7267.2 Fixed pocket (F)
MP7267.3 Locked pocket (L)
MP7267.4 PLC-Status (PLC)