HEIDENHAIN TNC 407 (243 020) Technical Manual - Manual (Page 20)

2-16
TNC 407/TNC 415/TNC 425 3 Software 01.98
TNC 415 A: 259 96x 04
TNC 415 E: 259 97x 04
TNC 407: 243 02x 04 Release 5/92
New functions:
– Multipoint axis error compensation: the maximum distance between compensation points was
increased to 2
23 .
– The maximum input range for position values was increased to –99 999.9999 mm to
+99 999,9999 mm.
– The override adjustment in 2 % steps was dropped.
– The minimum input value for MP6130 was changed to 1 mm and for MP6140 to 0.001 mm.
– MP440 was dropped.
– Mid-program startup (block scan) now works for ISO programs during blockwise transfer with
simultaneous execution.
−
New Module 9035
TNC 415 A: 259 96x 05
TNC 415 E: 259 97x 05
TNC 407: 243 02x 05 Release 5/92
New functions:
– The input value 4 was added to MP7480.
– The distance D to an auxiliary point with the coordinates PDX and PDY is now entered without
algebraic sign.
TNC 415 A: 259 96x 06
TNC 415 E: 259 97x 06
TNC 407: 243 02x 06 Release 9/92
New functions:
−
Electronic Handwheel mode
A new marker 2826 has been introduced. Setting this marker disables the evaluation of the
counting pulses received by the handwheel. The handwheel cannot be used to position when the
marker is set.
−
Transfer values to PLC
Numerical values can be entered in the new machine parameters MP4230.00 to MP4230.31 and
MP4231.0 to MP4231.31 which the PLC can read with module 9032.
MP4230.0 to MP4230.31 Transfer value to PLC with module 9032
MP4231.0 to MP4231.31
Entry: –99999.9999 to +99999.9999
−
DIN/ISO Programming
The maximum permitted length of an NC block in DIN/ISO has been increased from 130 to 150
characters.