HEIDENHAIN TNC 407 (243 020) Technical Manual - Manual (Page 447)

01.98
TNC 407/TNC 415/TNC 425 3 List of machine parameters 5-45
Machine
parameter Function and input Change
via Reaction Page
MP75x1 Supplementary identifier for transformation
Entry: %xx
Bit 0 Swivel axis
0 = swivel head
1 = tilting table
Bit 1 Dimension in MP75x2
0 = incremental step (for swivel
head)
1 = absolute related to machine
datum (for tilting table)
PLC EDIT 4-42
MP75x2 Dimension for transformation
Entry: –99,999.9999 to +99,999.9999
Entry 0 means "free rotating axis" PLC EDIT 4-42
3.13 Hardware
Machine
parameter Function and input Change
via Reaction Page
MP7620 Feed rate and spindle override
Entry: %xxxx
Bit 0 Feed rate override if rapid traverse button
is pressed in "program run"
0 = Override not active
1 = Override active
Bit 2 Feed rate override if rapid traverse
buttons and machine direction buttons are
pressed in "manual" operating mode
0 =
Override not active
1 = Override active
Bit 3 Spindle override in 1% increments or
according to a non-linear characteristic
curve
0 = 1% increments
1 = non-linear characteristic curve
PLC RUN 4-99