HEIDENHAIN TNC 407 (243 020) Technical Manual - Manual (Page 129)

4-4
TNC 407/TNC 415/TNC 425 1 Machine axes 01.98
7 M-functions 4-158
7.1 Program-halt on M-functions 4-161
7.2 Program-halt on M06 4-161
7.3 Modal cycle call M89 4-161
7.4 Reduced feed-rate of tool axis with M103 4-161
7.5 Selecting Kv factors with M105/M106 4-162
8 Key-simulation 4-164
8.1 TNC-keyboard (TE 400) 4-164
8.2 Machine-control panel 4-174
9 Touch probe 4-176
9.1 Standard touch probe cycles 4-176
9.2 Digitizing with TS 120 4-180
9.2.1 Scanning cycles 4-182
9.2.2 Response of the digitizing sequence at corners 4-183
9.2.3 Optimizing the digitizing sequence 4-185
9.3 Digitising with the TM 110 4-189
9.3.1 Interfacing the TM 110 4-189
9.4 Tool calibration with the TT 110 4-192
9.4.1 Interfacing the TT 110 4-192
10 Electronic handwheel 4-196
10.1 Integral handwheel HR 130 4-198
10.2 Portable handwheel HR 330 4-198
10.3 Portable handwheel HR 332 4-198
10.3.1 Assignment of keys and LEDs to the PLC inputs and outputs 4-199
10.3.2 PLC program example 4-200
10.4 HR 410 portable handwheel 4-201
10.5 Integral handwheels HR 150 with handwheel adapter HRA 110 4-202
10.5.1 Assignment of switch positions to the PLC inputs 4-203
10.5.2 PLC program example 4-204
11 Analogue inputs and outputs 4-206
11.1 Analogue inputs 4-206
11.2 Analogue outputs 4-207
12 Increment positioning 4-209
13 Hirth coupling 4-212
13.1 Positioning in Manual or Electronic Handwheel mode 4-212
13.2 Positioning in controlled mode 4-212
13.3 Program example 4-213
14 Datum correction 4-221