HEIDENHAIN TNC 407 (243 020) Technical Manual - Manual (Page 432)

5-30
TNC 407/TNC 415/TNC 425 3 List of machine parameters 01.98
Machine
parameter Function and input Change
via Reaction Page
MP6270 Rounding of decimal places
Entry: 0 to 2
0 = Output in 0.001 mm increments [1
µ
m]
1 = Output in 0.01 mm increments [10
µ
m]
2 = Output in 0.0001 mm increments [0.1
µ
m]
PLC RUN
CN 123 4-181
3.9.2 Digitizing with TM 110 (only with digitizing option)
Machine
parameter Function and input Change
via Reaction Page
MP6310 Stylus deflection depth (measuring touch probe)
Entry: 0.1000 to 2.0000 [mm] 4-190
MP6320 Counting direction of the measuring system signals
(measuring touch probe)
Entry: %xxx
Bit 0 =
X axis 0 = Positive
Bit 1 = Y axis 1 = Negative
Bit 2 = Z axis
4-190
MP6321 Measuring the centre offset while calibrating the
TM110
Entry: 0 or 1
0 = Calibrate and measure centre offset
1 = Calibrate without measuring centre offset
4-178
MP6322 Assignment of touch probe axes to the machine
axes
Entry: 0 to 2
0 =
Touch probe axis X
1 = Touch probe axis Y
2 = Touch probe axis Z
MP6322.0 Machine axis X
MP6322.1 Machine axis Y
MP6322.2 Machine axis Z
4-191
MP6330 Maximum stylus deflection (measuring touch
probe)
Entry: 0.1 to 4.000 [mm] 4-191
MP6350 Feed rate for positioning to the MIN point and
contour approach
(Measuring touch probe)
Entry: 10 to 3000 [mm/min] 4-191
MP6360 Probing feed rate (measuring touch probe)
Entry: 10 to 3000 [mm/min] 4-177
4-191
MP6361 Rapid traverse in scanning cycle (measuring touch
probe)
Entry: 10 to 10 000 [mm/min] 4-178
4-191