HEIDENHAIN TNC 407 (243 020) Technical Manual - Manual (Page 150)

01.98
TNC 407/TNC 415/TNC 425 1 Machine axes 4-25
MP712 Compensation value per cycle time
Entry: –0.000000 to 99.999999 (mm)
MP712.0 X axis
MP712.1 Y axis
MP712.2 Z axis
MP712.3 4th axis
MP712.4 5th axis
A second block of Kv factors can be activated with M function M105 (M106 deactivates).
A second block of machine parameters for reversal peak compensation is also activated.
MP715 (as MP711) and MP716 (as MP712)
MP715 Height of reversal peaks in circular movements (M105)
Entry: –1.0000 to +1.0000 (mm)
MP715.0 X axis
MP715.1 Y axis
MP715.2 Z axis
MP715.3 4th axis
MP715.4 5th axis
MP716 Compensation value per control loop cycle time (M105)
Entry: 0.000000 to 99.999999 [mm]
MP716.0 X axis
MP716.1 Y axis
MP716.2 Z axis
MP716.3 4th axis
MP716.4 5th axis