HEIDENHAIN TNC 407 (243 020) Technical Manual - Manual (Page 155)

4-30
TNC 407/TNC 415/TNC 425 1 Machine axes 01.98
Then the files AXIS-Y.COM and AXIS-Z.COM are assigned to the Y and Z axis respectively in a file of
the .CMA type (e.g. CONFIG.CMA).
A number of different assignments can be entered in the CONFIG.CMA file if required. Only one line
can be active at any one time. The active line is selected by soft key. In our example this must be
line 0.