HEIDENHAIN TNC 407 (243 020) Technical Manual - Manual (Page 187)

4-62
TNC 407/TNC 415/TNC 425 2 Reference marks 01.98
MP1320 Direction for traversing the reference marks
Entry: %xxxxx
Bit 0 X axis: 0 = positive
Bit 1 Y axis 1 = positive
Bit 2 Z axis
Bit 3 Axis 4
Bit 4 Axis 5
MP1330 Feed rate for traversing the reference marks
Entry: 80 to 30 000 [mm/min]
MP1330.0 X axis
MP1330.1 Y axis
MP1330.2 Z axis
MP1330.3 Axis 4
MP1330.4 Axis 5
MP1331 Feed rate for leaving the reference end-position
(only for rotary encoders MP1350=2)
Entry: 80 to 500 [mm/min]
MP1331.0 X axis
MP1331.1 Y axis
MP1331.2 Z axis
MP1331.3 Axis 4
MP1331.4 Axis 5
MP1340 Sequence for traversing reference marks
Entry: 0 = no evaluation of the reference mark
1 = X axis
2 = Y axis
3 = Z axis
4 = Axis 4
5 = Axis 5
MP1340.0 1st axis
MP1340.1 2nd axis
MP1340.2 3rd axis
MP1340.3 4th axis
MP1340.4 5th axis