HEIDENHAIN TNC 407 (243 020) Technical Manual - Manual (Page 420)

5-18
TNC 407/TNC 415/TNC 425 3 List of machine parameters 01.98
Machine
parameter Function and input Change
via Reaction Page
MP1513 Feed-rate limit for stiction compensation
Entry: 0 to 300 000 [mm/min]
MP1513.0 X axis
MP1513.1 Y axis
MP1513.2 Z axis
MP1513.3 4th axis
MP1513.4 5th axis
PLC RUN 4-33
MP1515 k
v
factor for feed precontrol activated (M105)
Entry: 0.100 to 20.000 [
m/min
mm
]
MP1510.0 X axis
MP1510.1 Y axis
MP1510.2 Z axis
MP1510.3 4th axis
MP1510.4 5th axis
PLC RUN 4-76
MP1520 Transient response
Entry: 0.100 to 10.000 PLC EDIT 4-76
MP1525 Maximum velocity for checking the positioning
window
Entry: 0.100 to 10.000 [mm/min]
Recommended value: 0.5 [mm/min] PLC EDIT 4-87
MP1530 Damping factor for transient response
Only with software types 243 05, 259 96, 243 07,
243 02.
Entry: 0.010 to 0.999
PLC EDIT 4-76
3.4 Operation with servo lag
Machine
parameter Function and input Change
via Reaction Page
MP1710 Position monitoring for operation with lag
(cancellable)
Entry: 0.0000 to 300.0000 [mm]
MP1710.0 X axis
MP1710.1 Y axis
MP1710.2 Z axis
MP1710.3 4th axis
MP1710.4 5th axis
PLC EDIT 4-84