Nominal value output, Connector assignment, Connecting cable – HEIDENHAIN TNC 407 (243 020) Technical Manual User Manual
Page 62: X8 = nominal value - output, 1, 2, 3, 4, 5, s, 36 nominal value output, 1 connector assignment x8, 2 connecting cable

3-32
TNC 407/TNC 415/TNC 425
6 Nominal value output
01.98
3
6 Nominal value output
HEIDENHAIN contouring controls control the position loop servo with a nominal value potential of
±
10 volts.
Maximum loading of the nominal value outputs: 2 mA
Maximum load capacitance: 2 nF
6.1 Connector assignment
X8
Nominal value output 1
Do not use
Nominal value output 2
Nominal value output 5
Nominal value output 3
0V Nominal value output 5
Nominal value output 4
Nominal value output S axis
0V Nominal value output 1
Do not use
0V Nominal value output 2
Do not use
0V Nominal value output 3
0V Nominal value output 4
0V Nominal value output S axis
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
BN
BN/GN
YL
RD/BL
PK
GY/PK
RD
VI
WH
WH/GY
GN
GY
BL
BK
max. 20 m
Id.-Nr. 290 109..
X8 Nominal value output
•
Id.-Nr. 290 110..
6.2 Connecting cable
HEIDENHAIN offers a connecting cable with a connector at one end (Id.-Nr. 290 109 ..).
The connecting cable to the nominal value outputs may not have more than one intermediate
terminal. The terminal must be made in an earthed connection box. This is necessary when the
cable must branch to physically separate servo inputs. It is only possible to earth the screening of
the servo leads in this way. If required, suitable connection boxes are available from HEIDENHAIN
with the Id.-Nr. 251 249 01.