HEIDENHAIN ND 286 - Manual

HEIDENHAIN
Working with the position ND 286
display unit
Indicator Meaning
REF If the decimal points have stopped blinking:
Reference mark was crossed over — datum points are now stored
in nonvolatile memory.
Blinking: Waiting for operator to press ENT or CL.
in. Position values displayed in inches.
1 / 2 Datum 1 / Datum 2 currently active.
PRINT Blinking: Waiting for ENT for data output.
SET Blinking: Waiting for operator to confirm entry.
< / = / > Sorting mode: Measured value less than lower limit / within
tolerances / greater than upper limit.
MIN / MAX Measuring series: Minimum / Maximum /
DIFF / ACTL largest difference (MAX–MIN) / current measured value.
Blinking: Waiting for confirmation of value to be displayed.
START Measuring series in progress.
Blinking: Waiting for start signal for measuring series.
HEIDENHAIN
REF 2 1 SET START PRINT in.
MIN ACTL MAX DIFF = < >
7 8 9
4 5 6
1 2 3
0
.
– CL
MOD
• Clear entry
• Reset to zero (P80!)
• CL plus MOD:
parameter list
• CL plus 2-digit num-
ber: select parameter
• Clear parameter entry
and show parameter
number
Status display • Algebraic
sign
• Decrease
parameter
value
Actual value and input display
(7-segment LED,
9 decades and sign)
Numeric keypad
• Switch display to:
MIN / MAX / DIFF / ACTL / START / PRINT
• Go to parameter list after switch-on
• Page forward in parameter list
• Select datum
• Page backward in
parameter list
• Confirm entry value
• Set display to value from
P79 (P80!)
• Decimal point
• Increase pa-
rameter value