HEIDENHAIN TNC 407 (243 020) Technical Manual - Manual (Page 431)

01.98
TNC 407/TNC 415/TNC 425 3 List of machine parameters 5-29
3.9 Measuring with a 3D touch probe
Machine
parameter Function and input Change
via Reaction Page
MP6010 Selection of the touch probe system
Entry: 0 or 1
0 = TS 120
1 = TS 511 PLC EDIT
CN 123 4-177
3.9.1 Digitizing with TS 120 (only with digitizing option)
Machine
parameter Function and input Change
via Reaction Page
MP6120 Probing feed rate (triggering touch probe)
Entry: 10 to 3000 [mm/min] PLC RUN
CN 123 4-177
MP6130 Maximum measuring range
Entry: 0.001 to 99 999.9999 [mm] PLC RUN
CN 123 4-177
MP6140 Safety-clearance over measurement point
Entry: 0.001 to 99 999.9999 [mm] PLC RUN
CN 123 4-177
MP6150 Rapid traverse for probe cycle (triggering touch
probe)
Entry: 10 to 10000 [mm/min] PLC RUN
CN 123 4-177
MP6160 Spindle orientation for 180
°
rotation
Entry: –1 to 88
–1
= Spindle orientation directly through NC
0 = Function not active
1 to 88 = Number of the M function for spindle
orientation by PLC
PLC RUN
CN 123 4-178
MP6200 Selection of triggering or measuring touch probe
system (only with "Digitizing with TM 110" option)
Entry: 0 or 1
0 = Triggering touch probe (e.g. TS 120)
1 = Measuring touch probe(e.g.. TM 110) 4-177
MP6210 Number of oscillations per second in normal
direction
Entry: 0 to 65 535 [Hz] PLC RUN
CN 123 4-181
MP6220 Traverse for lubricating the probe axis at end of line
Entry: 0.000 to 99 999.999 [mm] 4-182
MP6221 Time after which the probe axis must be lubricated
Entry: 0 to 65 535 [min] 4-182
MP6230 Feed rate in normal direction
Entry: 0 to 1000 [mm/min] PLC RUN
CN 123 4-181
MP6240 Maximum deflection of stylus
Entry: 0 to 10.000 [mm] PLC RUN
CN 123 4-181
MP6260 Output of M90 on NC blocks of digitized data
Entry: 0 or 1
0 = no output of M90
1 = output of M90 in every NC block PLC RUN
CN 123 4-181