HEIDENHAIN TNC 407 (243 020) Technical Manual - Manual (Page 460)

01.98
TNC 407/TNC 415/TNC 425 2 List of words 6-11
Words Function Page
W516 Word with multiple function
Key code for simulating TNC keys
activated by M2813
Number of the Q-parameter to be overwritten (Q100 to Q107 = 0 to 7) 4-154
4-164
B518 0 = ”Free-rotation” function cancelled
8 = ”Free-rotation” function for axis 4
16 = ”Free-rotation” function for axis 5 4-136
B519 Definition of the direction of traverse 4-136
B520 Axis specific feed rate release
Bit 0 +1 Feed rate enable in the X axis
+0 No feed rate enable X in the axis
Bit 1 +2 Feed rate enable in the Y axis
+0 No feed rate enable in the Y axis
Bit 2 +4 Feed rate enable in the Z axis
+0 No feed rate enable in the Z axis
Bit 3 +8 Feed rate enable in the 4th axis
+0 No feed rate enable in the 4th axis
Bit 4 +16 Feed rate enable in the 5th axis
+0 No feed rate enable in the 5th axis
4-90
W522 Monitoring functions suppressed if PLC
input from MP4130 is activated 4-83
D528 Value to be transferred to the Q parameter
Axis X datum correction
Position of X axis [1/10 000 mm] 4-154
4-222
4-35
D532 Axis Y datum correction
Position Y axis
D536 Axis Z datum correction
Position Z axis
D540 Axis IV datum correction
Position 4 axis
D544 Axis V datum correction
Position 5 axis
W560 Feed X axis [mm/min] 4-35
W562 Feed Y axis 4-35
W564 Feed Z axis 4-35
W566 Feed axis 4 4-35
W568 Feed axis 5 4-35
W576
to
W584
W576
W578
W580
W582
W584
Lag tracking error compensation
(compensation speed from MP4070)
Input range: +32 767 to –32 768 [
1
10
µ
m]
Axis X
Axis Y
Axis Z
Axis 4
Axis 5
4-32
D592 Nominal position for spindle orientation (Strobe M2712) 4-106
D596 Rapid traverse from PLC 4-70
W754 %-factor of feed-override "feed rotation" (0 to 300 %) 4-136
D756 Set spindle-speed from the PLC; programmed spindle speed 4-101