HEIDENHAIN TNC 407 (243 020) Technical Manual - Manual (Page 410)

5-8
TNC 407/TNC 415/TNC 425 3 List of machine parameters 01.98
Machine
parameter Function and input Change
via Reaction Page
MP120.0-4 Assignment of the nominal value outputs
Entry: 0 to 5
0 = output 1
1 = output 2
2 = output 3
3 = output 4
4 = output 5
5 = output S
MP120.0 X axis
MP120.1 Y axis
MP120.2 Z axis
MP120.3 4th axis
MP120.4 5th axis
RESET 4-14
MP210 Count direction of the measuring system signals
Entry: %xxxxx
Bit 0 X axis 0 = positive
Bit 1 Y axis 1 = negative
Bit 2 Z axis
Bit 3 4th axis
Bit 4 5th axis
RESET 4-8
MP330.0-4 Signal period
Entry: 0.100 to 1000.000 [
µ
m] or
[ 1°
1000
]
MP330.0 X axis
MP330.1 Y axis
MP330.2 Z axis
MP330.3 4th axis
MP330.4 5th axis
PLC EDIT REF 4-7
MP340.0-4 Interpolation factor of the EXE at X5, X6
(only TNC407)
Entry: 0,1, 5
0 = no measuring system on X5, X6 or
EXE without interpolation
1 = EXE without interpolation
5 = EXE with 5-fold interpolation
MP340.0 X axis
MP340.1 Y axis
MP340.2 Z axis
MP340.3 4th axis
MP340.4 5th axis
4-8