PLANET XGS3-24040 - Manual (Page 868)

64-2
Default: A different default rate is set for the different type of protocol.
Usage Guide: The rate limit set by this command have an effect on CPU receiving packets, so it is
supposed to be used with the help of the technical support.
Example: Set the rate of the CPU receiving the arp packets to 500pps.
Switch(config)#cpu-rx-ratelimit protocol arp 500
64.4 clear cpu-rx-stat protocol
Command: clear cpu-rx-stat protocol []
Function: Clear the statistics of the CPU received packets of the protocol type.
Parameter: is the type of the protocol of the packet, including dot1x, stp, snmp, arp,
telnet, http, dhcp, igmp, ssh, bgp, bgp4plus, rip, ripng, ospf, ospfv3, pim, pimv6, unknown-mcast,
unknow-mcast6, mld.
Command Mode: Global Mode
Usage Guide: This command clear the statistics of the CPU received packets of the protocol type, it is
supposed to be used with the help of the technical support.
Example: Clear the statistics of the CPU receives arp packets.
Switch(config)#clear cpu-rx-stat protocol arp
64.5 cpu-rx-ratelimit channel
This type of switch does not support the command.
64.6 show cpu-rx protocol
Command: show cpu-rx protocol []
Function: Show the statistics of the CPU received packets of the protocol type.
Parameter: <protocol- type> is the type of the protocol of the packet.
Command Mode: Admin Mode
Default: None.
Usage Guide: This command is used to debug, it is supposed to be used with the help of the technical
support.
Example：Show the statistics of the CPU receiving arp packets.
Switch#show cpu-rx protocol arp
Type Rate-limit TotPkts CurState
arp 500 3 allowed
64.7 debug driver
Command: debug driver {receive | send} [interface { | all}] [protocol
{ | discard | all}] [detail]
no debug driver {receive | send}