PLANET XGS3-24040 - Manual (Page 795)

49-1
Chapter 49 Commands for IPv6
Security RA
49.1 ipv6 security-ra enable
Command: ipv6 security-ra enable
no ipv6 security-ra enable
Function: Globally enable IPv6 security RA function, all the RA advertisement messages will not be
forwarded through hardware, but only sent to CPU to handle. The no operation of this command will
globally disable IPv6 security RA function.
Parameters: None.
Command Mode: Global Configuration Mode.
Default: The IPv6 security RA function is disabled by default.
Usage Guide: Only after globally enabling the security RA function, can the security RA on a port be
enabled. Globally disabling security RA will clear all the configured security RA ports.
Example: Globally enable IPv6 security RA.
Switch(config)#ipv6 security-ra enable
49.2 ipv6 security-ra enable
Command: ipv6 security-ra enable
no ipv6 security-ra enable
Function: Enable IPv6 security RA on a port, causing this port not to forward the received RA message.
The no ipv6 security-ra enable will disable the IPv6 security RA on a port.
Parameters: None.
Command Mode: Port Configuration Mode.
Default: IPv6 security RA function is disabled by default.
Usage Guide: Only after globally enabling the security RA function, can the security RA on a port be
enabled. Globally disabling security RA will clear all the configured security RA ports.
Example: Enable IPv6 security RA on a port.
Switch(Config-If-Ethernet1/2)#ipv6 security-ra enable
49.3 show ipv6 security-ra
Command: show ipv6 security-ra [interface ]
Function: Display all the interfaces with IPv6 RA function enabled.
Parameters: No parameter will display all distrust ports, entering a parameter will display the
corresponding distrust port.
Command Mode: Admin and Configuration Mode.
Example:
Switch# show ipv6 security-ra
IPv6 security ra config and state information in the switch
Global IPv6 Security RA State: Enable