PLANET XGS3-24040 - Manual (Page 308)

23-21
23.8 ipv6 nd snooping policy
Command:
ipv6 nd snooping policy {bind-eui64-address | bind-non-eui64-address}
no ipv6 nd snooping policy {bind-eui64-address | bind-non-eui64-address}
Function:
Configure the dynamic binding policy of ND Snooping addresses.
Parameter:
bind-eui64-address means only the address of the global unicast EUI-64 is bound,
bind-non-eui64-address means the global unicast address of non EUI-64 is bound, default means
the global unicast address is bound.
Command mode:
Global Mode.
Default:
Bind any global unicast addresses by default.
Usage Guide:
After the policy is configured, only bind the IPv6 addresses which are specified by the policy, a
message is displayed for a non policy specifies the global unicast address to report the conflict.
Example:
Configure binding the global unicast EUI-64.
Switch(config)#ipv6 nd snooping enable
Switch(config)#ipv6 nd snooping policy bind-eui64-address
23.9 ipv6 nd snooping port-binding-limit
Command:
ipv6 nd snooping port-binding-limit
no ipv6 nd snooping port-binding-limit
Function:
Configure the binding number of the port. This binding number only limits the dynamic binding
number of the port, but do not limit the number of the static binding.
Parameter:
binding-limit is the max number which can be bound for each port, the range from 1 to 100.
Command mode:
Port Mode.
Default:
100
Usage Guide:
a) After receiving this configuration command, set the max value of the dynamic binding for this
port.
b) Check the dynamic binding of this port and account the number of the dynamic binding. If the
number exceeds this configuration value, then delete some dynamic binding which have a high