PLANET XGS3-24040 - Manual (Page 282)

17-40
no urpf enable
Function:
Enable the global URPF function.
Parameters:
None
Command mode:
Global Mode
Default:
The URPF protocol module is disabled by default.
Usage Guide:
None
Example:
Switch(config)#urpf enable
17.5 Commands for ARP Configuration
17.5.1 arp
Command:
arp > {interface [ethernet] <portName>}
no arp
Function:
Configures a static ARP entry; the “no arp ” command deletes a ARP entry of the
specified IP address.
Parameters:
is the IP address, at the same filed with interface address; is the
MAC address; ethernet stands for Ethernet port; for the name of layer2 port.
Default:
No static ARP entry is set by default.
Command mode:
VLAN Interface Mode
Usage Guide:
Static ARP entries can be configured in the switch.
Example:
Configuring static ARP for interface VLAN1.
Switch(Config-if-Vlan1)#arp 1.1.1.1 00-30-4f-f0-12-34 eth 1/2