PLANET XGS3-24040 - Manual (Page 687)

XGS3 Command Guide
39-19
39.3.16 ipv6 pim exclude-genid
Command: ipv6 pim exclude-genid
no ipv6 pim exclude-genid
Function: This command makes the Hello packets sent by PIM SM do not include GenId option, the “no
ipv6 pim exclude-genid” command restores the default value.
Parameter: None
Default: The Hello packets include GenId option.
Command Mode: Interface Configuration Mode
Usage Guide: This command is used to interact with older Cisco IOS version. The command can
configure on IPv6 tunnel interface, but it is successful configuration to only configure tunnel carefully.
Example: Configure the Hello packets sent by the switch do not include GenId option.
Switch(Config-if-Vlan1)#ipv6 pim exclude-genid
39.3.17 ipv6 pim hello-holdtime
Command: ipv6 pim hello-holdtime <value>
no ipv6 pim hello-holdtime
Function: Configure or disable the Holdtime option in the Hello packets, this value is to describe
neighbor holdtime, if the switch hasn’t received the neighbor hello packets when the holdtime is over, this
neighbor is deleted.
Parameter: <value> is the value of holdtime.
Default: The default value of Holdtime is 3.5*Hello_interval, Hello_interval’s default value is 30s,so
Holdtime’s default value is 105s.
Command Mode: Interface Configuration Mode
Usage Guide: If this value is not configured, hellotime’s default value is 3.5*Hello_interval. If the
configured holdtime is less than the current hello_interval , this configuration is denied. Every time
hello_interval is updated, the Hello_holdtime will update according to the following rules: If hello_holdtime
is not configured or hello_holdtime is configured but less than current hello_interval,hello_holdtime is
modified to 3.5*hello_interval, otherwise the configured value is maintained. The command can configure
on IPv6 tunnel interface, but it is successful configuration to only configure tunnel carefully.
Example: Configure vlan1’s Hello Holdtime to 10s
Switch (config)# interface vlan1
Switch (Config -if-Vlan1)#ipv6 pim hello-holdtime 10
39.3.18 ipv6 pim hello-interval
Command: ipv6 pim hello-interval <interval>
no ipv6 pim hello-interval
Function: Configure the interface’s hello_interval of pim hello packets. The “no ipv6 pim hello-interval”
command restores the default value.
Parameter: <interval> is the hello_interval of periodically transmitted pim hello packets’, ranges from 1
to 18724s