PLANET XGS3-24040 - Manual (Page 575)

XGS3 Command Guide
38-4
38.2.5 ip pim dense-mode
Command: ip pim dense-mode
no ip pim dense-mode
Function: Enable PIM-DM protocol on interface; the “no ip pim dense-mode” command disenables
PIM-DM protocol on interface.
Parameter: None.
Default: Disable PIM-DM protocol.
Command Mode: Interface Configure Mode
Usage Guide: The command will be taken effect, executing ip multicast-routing in Global Mode. Don’t
support multicast protocol mutual operation, namely can’t synchronously enable dense mode and sparse
mode in one swtich.
Example: Enable PIM-DM protocol on interface vlan1.
Switch (config)#ip pim multicast-routing
Switch (config)#interface vlan 1
Switch(Config-if-Vlan1)#ip pim dense-mode
38.2.6 ip pim dr-priority
Command: ip pim dr-priority <priority>
no ip pim dr-priority
Function: Configure, disable or change the interface’s DR priority. The neighboring nodes in the same
net segment select the DR in their net segment according to hello packets. The “no ip pim dr-priority”
command restores the default value.
Parameter: is priority
Default: 1
Command Mode: Interface Configuration Mode
Usage Guide: Range from 0 to 4294967294, the higher value has more priority.
Example: Configure vlan’s DR priority to 100
Switch (config)# interface vlan 1
Switch(Config-if-Vlan1)ip pim dr-priority 100
Switch (Config -if-Vlan1)#
38.2.7 ip pim exclude-genid
Command: ip pim exclude-genid
no ip pim exclude-genid