PLANET XGS3-24040 - Manual (Page 157)

11-23
When GARP application entity wants to cancel a certain property information, it sends a leave
message. GARP application entities receiving this message will start the leave timer, if no join
message is received before leave timer timeout, the property information will be canceled. Besides,
the value of leave timer must be twice larger than the join timer. Otherwise, an error message will be
displayed.
Example:
Set the GARP leave timer value of port 1/10 to 3000 ms.
Switch(Config-If-Ethernet1/10)#garp timer leave 3000
11.1.8 garp timer leaveall
Command:
garp timer leaveall <timer-value>
no garp timer leaveall
Function:
Set the leaveall timer for GARP; the “no garp timer leaveall” command restores the default timer
setting.
Parameter:
is the value for GARP leaveall timer, the valid range is 100 to 327650 ms.
Command mode:
Global Mode.
Default:
The default value for leaveall timer is 10000 ms.
Usage Guide:
When a GARP application entity starts, the leaveall timer is started at the same time. When the
leaveall timer is over, the GARP application entity will send a leaveall message. Other application
entities will cancel all property information for that application entity, and the leaveall timer is cleared
for a new cycle.
Example:
Set the GARP leaveall timer value to 50000 ms.
Switch(config)#garp timer leaveall 50000
11.1.9 name
Command:
name
no name
Function:
Specify a name, a descriptive string, for the VLAN; the no operation of the command will delete the
name of the VLAN.
Parameters:
is the specified name string.
Command Mode: