PLANET XGS3-24040 - Manual (Page 834)

Commands for Reliability Chapter 4 Commands for ULPP
57-9
Switch(config)# interface ethernet 1/1
Switch(config-If-Ethernet1/1)# ulpp flush enable mac
57.23 ulpp group
Command: ulpp group
no ulpp group
Function: Create a ULPP group. If this group exists, then enter the configuration mode of ULPP group.
The no command deletes a ULPP group.
Parameter: <integer> is the ID of ULPP group, range from 1 to 48.
Command mode: Global Mode.
Default: Any ULPP groups are not configured.
Usage Guide: None.
Example: Configure ulpp group 20 or enter the mode of ulpp group 20.
Switch(config)# ulpp group 20
Switch(ulpp-group-20)#
57.24 ulpp group master
Command: ulpp group master
no ulpp group master
Function: Configure the master port of ULPP group, the no command deletes the master port.
Parameter: is the ID of ULPP group, range from 1 to 48.
Default: There is no master port configured by default.
Command mode: Port mode.
Usage Guide: There are no sequence requirement for the master and slave port configuration in a group,
but the protective VLANs must be configured before the member ports. Each group has only one master
port, if the master port exists, then the configuration fail.
Example: Configure the master port of ULPP group.
Switch(config)# interface ethernet 1/1
Switch(config-If-Ethernet1/1)# ulpp group 20 master
57.25 ulpp group slave
Command: ulpp group slave
no ulpp group slave
Function: Configure the slave port of ULPP group, the no command deletes the slave port.
Parameter: is the ID of ULPP group, the range from 1 to 48.
Default: There is no slave port configured by default.