PLANET XGS3-24040 - Manual (Page 136)

8-2
Switch(Config-if-ethernet 1/5)#lldp disable
8.3 lldp mode
Command: l
ldp mode <send|receive|both|disable>
Function:
Configure the operating state of LLDP function of the port.
Parameters:
send: Configure the LLDP function as only being able to send messages.
receive: Configure the LLDP function as only being able to receive messages.
both: Configure the LLDP function as being able to both send and receive messages.
disable: Configure the LLDP function as not being able to send or receive messages.
Default:
The operating state of the port is “both”.
Command Mode:
Port Configuration Mode.
Usage Guide:
Choose the operating state of the lldp Agent on the port.
Example:
Configure the state of port ethernet 1/5 of the switch as “receive”.
Switch(config)#in ethernet 1/5
Switch(Config-if-Ethernet 1/5)#lldp mode receive
8.4 lldp tx-interval
Command:
lldp tx-interval
no lldp tx-interval
Function:
Set the interval of sending update messages on all the ports with LLDP function enabled, the value
of which ranges from 5 to 32768 seconds and is 30 seconds by default.
Parameters:
<seconds>is the interval of sending updating messages, ranging from 5 to 32768 seconds.
Default:
30 seconds.
Command Settings:
Global Mode.
Usage Guide:
After configuring the interval of sending messages, LLDP messages can only be received after a