PLANET XGS3-24040 - Manual (Page 685)

XGS3 Command Guide
39-17
immediately and does not create group records when receiving REGISTER packets. Unlike other
access-list, when the access-list is configured ,the default value is PERMIT..
Example: Configure the filtered register message’s rule to myfilter.
Switch(config)#ipv6 pim accept-register list myfilter
Switch(config)#ipv6 access-list standard myfilter
Switch(config_IPv6_Std-Nacl-myfilter)#permit ff1e::10/128
39.3.12 ipv6 pim bsr-border
Command: ipv6 pim bsr-border
no ipv6 pim bsr-border
Function: To configure or delete PIM6 BSR-BORDER interface.
Parameter: None.
Default: Non-BSR-BORDER.
Command Mode: Interface Configuration Mode.
Usage Guide: To configure the interface as the BSR-BORDER. If configured, BSR related messages will
not receive from or sent to the specified interface. All the networks connected to the interface will be
considered as directly connected.
Example:
Switch(Config-if-Vlan1)#ipv6 pim bsr-border
39.3.13 ipv6 pim bsr-candidate
Command: ipv6 pim bsr-candidate {vlan |tunnel |}
[] []
no ipv6 pim bsr-candidate {vlan | tunnel |}
[] []
Function: This command is the candidate BSR configure command in global mode and is used to
configure PIM-SM information about candidate BSR in order to compete the BSR router with other
candidate BSRs. The command “no ipv6 pim bsr-candidate {vlan | tunnel
|} [] []” command disables the candidate BSR.
Parameter: is VLAN ID ,the value ranges from 1 to 4094;
is tunnel ID,the value ranges from 1 to 50;
<ifname> is the specified interface name;
[hash-mask-length] is the specified hash mask length. It’s used for the RP enable selection
and ranges from 0 to 32;
[priority] is the candidate BSR priority and ranges from 0 to 255. If this parameter is not
configured, the default priority value is 0.
Default: This switch is not a candidate BSR router
Command Mode: Global Mode
Usage Guide: This command is the candidate BSR configure command in global mode and is used to