PLANET XGS3-24040 - Manual (Page 711)

XGS3 Command Guide
39-43
: MAC address.
Default: None.
Command Mode: Admin Mode.
Usage Guide: Use this command to display the configured multicast destination control rules, if including
the detail option, it will also display the details of the access-list in use.
Example:
switch(config)#show ipv6 multicast destination-control
ipv6 multicast destination-control is enabled
ipv6 multicast destination-control 2003::1/64 access-group 9003
ipv6 multicast destination-control 1 00-03-05-07-09-11 access-group 9001
multicast destination-control access-group 6000 used on interface Ethernet1/13
switch(config)#
39.6.11 show ipv6 multicast destination-control
access-list
Command: show ip multicast destination-control access-list
show ip multicast destination-control access-list <9000-10999>
Function: Display the configured IPv6 destination control multicast access list.
Parameters: <9000-10099>: Access list number.
Default: None.
Command Mode: Admin Mode.
Usage Guide: Use this command to display the configured IPv6 destination control multicast access list.
Example:
switch# sh ipv6 multicast destination-control acc
ipv6 access-list 9000 permit 2003::2/64 ff1e::3/64
ipv6 access-list 9000 deny 2008::1/64 ff1e::1/64
ipv6 access-list 9000 permit any-source any-destination
ipv6 access-list 9001 deny any-source host-destination ff1a::1
ipv6 access-list 9001 permit any-source any-destination
39.6.12 show ipv6 multicast policy
Command: show ipv6 multicast policy
Function: Display the configured IPv6 multicast policy.
Parameters: None.
Default: None.
Command Mode: Admin Mode.
Usage Guide: Use this command to display the configured IPv6 multicast policy.
Example:
switch#show ipv6 multicast policy