PLANET XGS3-24040 - Manual (Page 758)

Commands for Security Function Chapter 2 Commands for 802.1x
42-30
access to the limited resources when the host is not authenticated yet. While the user based advanced
access control can control the access to the limited resources before authentication is done.
Webbased access management is used mostly in layer switch. The global configuration of WEB
authentication agent and HTTP redirection address is needed before setting the port to Webbased
access management. Webbased access management is conflicted with the command of ip dhcp
snooping binding user-control.
Notes: The 802.1x free resource must be configured first for standard control method based on user.
Example: To configure the standard control method based on port for Etherent1/4.
Switch(Config-If-Ethernet1/4)#dot1x port-method portbased
42.17 dot1x privateclient enable
Command: dot1x privateclient enable
no dot1x privateclient enable
Function: To configure the switch to force the authentication client to use private 802.1x authentication
protocol. The no prefix will disable the command and allow the authentication client to use the standard
802.1x authentication protocol.
Command: Global Mode.
Default: Private 802.1x authentication packet format is disabled by default.
Usage Guide: To implement integrated solution, the switch must be enabled to use private 802.1x
protocol, or many applications will not be able to function. If the switch forces the authentication client to
use private 802.1x protocol, the standard client will not be able to work.
Example: To force the authentication client to use private 802.1x authentication protocol.
Switch(config)#dot1x privateclient enable
42.18 dot1x re-authenticate
Command: dot1x re-authenticate [interface ]
Function: Enables real-time 802.1x re-authentication (no wait timeout requires) for all ports or a
specified port.
Parameters: stands for port number, omitting the parameter for all ports.
Command mode: Global Mode.
Usage Guide: This command is an Global Mode command. It makes the switch to re-authenticate the
client at once without waiting for re-authentication timer timeout. This command is no longer valid after
authentication.
Example: Enabling real-time re-authentication on port1/8.
Switch(config)#dot1x re-authenticate interface ethernet 1/8
42.19 dot1x re-authentication
Command: dot1x re-authentication
no dot1x re-authentication