PLANET XGS3-24040 - Manual (Page 655)

XGS3 Command Guide
38-84
38.10.11 ip igmp snooping vlan mrouter-port interface
Command: ip igmp snooping vlan <vlan-id> mrouter-port interface [ | ]
no ip igmp snooping vlan <vlan-id> mrouter-port interface [ |
]
Function: Configure static mrouter port of vlan. The no form of the command cancels this configuration.
Parameter: vlan-id: ranging between <1-4094>
ehternet: Name of Ethernet port
ifname: Name of interface
port-channel: Port aggregation
Command Mode: Global mode
Default: No static mrouter port on vlan by default.
Usage Guide: When a port is a static mrouter port while also a dynamic mrouter port, it should be taken
as a static mrouter port. Deleting static mrouter port can only be realized by the no command.
Example:
Switch(config)#ip igmp snooping vlan 2 mrouter-port interface ethernet1/13
38.10.12 ip igmp snooping vlan mrpt
Command: ip igmp snooping vlan <vlan-id> mrpt <value>
no ip igmp snooping vlan <vlan-id> mrpt
Function: Configure this survive time of mrouter port.
Parameter: vlan-id: vlan ID, ranging between <1-4094>
value: mrouter port survive period, ranging between <1-65535>seconds
Command Mode: Global mode
Default: 255s
Usage Guide: This command validates on dynamic mrouter ports but not on mrouter port. To use this
command, IGMP Snooping of this vlan should be enabled previously.
Example:
Switch(config)#ip igmp snooping vlan 2 mrpt 100
38.10.13 ip igmp snooping vlan query-interval
Command: ip igmp snooping vlan <vlan-id> query-interval <value>
no ip igmp snooping vlan <vlan-id> query-interval
Function: Configure this query interval.
Parameter: vlan-id: vlan id , ranging between <1-4094>
value: query interval, ranging between <1-65535>seconds
Command Mode: Global mode
Default: 125s