PLANET XGS3-24040 - Manual (Page 502)

34-215
34.24 max-concurrent-dd
Command: max-concurrent-dd
no max-concurrent-dd
Function: Configure with this command the current dd max concurrent number in the OSPF processing.
The “no max-concurrent-dd” command restores the default.
Parameter: <value> ranges between <1-65535>, the capacity of concurrent dd data packet processing.
Default: No default configuration. No dd concurrent limit.
Command Mode: OSPFv3 protocol mode
Usage Guide: Specify the current dd max concurrent number in the OSPF processing.
Example: Set the max concurrent dd to 20.
Switch # config terminal
Switch (config)# router ipv6 ospf
Switch(config-router)#max-concurrent-dd 20
34.25 passive-interface
Command: [no] passive-interface {|vlan }
Function: Configure that the hello group not sent on specific interfaces. The “no
passive-interface{|vlan }” command cancels this function.
Parameter: is the specific name of interface.
Default: Not configured
Command Mode: OSPFv3 protocol mode
Example:
Switch # config terminal
Switch (config)# router ipv6 ospf
Switch(config-router)#passive-interface vlan1
34.26 redistribute
Command: [no] redistribute {kernel |connected| static| rip| isis| bgp} [metric<value>] [metric-type
{1|2}][route-map]
Function: Introduce route learnt from other routing protocols into OSPFv3.
Parameter: kernel Introduct from kernel route
connected Introduce from direct route
static Introduce from static route
rip Introduce from the RIP route
isis Introduce from ISIS route
bgp Introduce from BGP route