PLANET XGS3-24040 - Manual (Page 226)

14-92
Command:
policy-map <policy-map-name>
no policy-map <policy-map-name>
Function:
Creates a policy map and enters the policy map mode; the “no policy-map <policy-map-name>”
command deletes the specified policy map.
Parameters:
< policy-map-name> is the policy map name.
Default:
No policy map is configured by default.
Command mode:
Global Mode
Usage Guide:
PBR classification matching and marking next hop operations can be done in the policy map
configuration mode.
Example:
Creating and deleting a policy map named “p1”.
Switch(config)#policy-map p1
Switch(Config-PolicyMap-p1)#exit
Switch(config)#no policy-map p1
14.8 priority-queue out
Command:
priority-queue out
no priority-queue out
Function:
Configure the dequeue mode. The no operation of this command will reset it to default value. At the
same time, reset the weight of the output queue to default value.
Parameters:
None
Default:
Non priority-queue mode.
Command Mode:
Interface Configuration Mode.
Usage Guide:
When adopting priority-queue as dequeue mode, the WRR weighting algorithm will not be used to
send messages. Instead, messages from the low-priority queue can only be sent after those ones
from the high-priority queue are all sent.
Examples:
Set the dequeue mode of port ethernet1/1as priority-queue mode.