PLANET XGS3-24040 - Manual (Page 705)

XGS3 Command Guide
39-37
self-rp-address:
The configured self-rp-address.
anycast-rp address:
The configured anycast-rp-address.
other rp unicast rp address:
The configured other RP communication addresses in accordance with the above anycast-rp-address.
other rp unicast rp address:
The configured other RP communication addresses in accordance with the above anycast-rp-address.
anycast-rp address:
The configured anycast-rp-address*.
other rp unicast rp address:
The configured other RP communication addresses in accordance with the above anycast-rp-address.
39.5 Commands for PIM-SSM6
39.5.1 ipv6 pim ssm
Command: ipv6 pim ssm {default|range <access-list-name >}
no ipv6 pim ssm
Function: Configure the range of pim ssm multicast address. The “no ipv6 pim ssm” command deletes
configured pim ssm multicast group.
Parameter: default: indicates the default range of pim ssm multicast group is ff3x::/32.
is the name of applying access-list.
Default: Do not configure the range of pim ssm group address
Command Mode: Global Mode
Usage Guide:
1. Only this command is configured, pim ssm can be available.
2. Before configuring this command, make sure ipv6 pim multicasting succeed.
3. Access-list only can use the lists created by ipv6 access-list.
4. Users can execute this command first and then configure the corresponding acl; or delete
corresponding acl in the bondage. After the bondage, only command no ipv6 pim ssm can release the
bondage.
5. If ssm is needed, this command should be configured at the related edge route. For example, the local
switch with igmp(must) and multicast source DR or RP(at least one of the two) configure this command,
the middle switch need only enable PIM-SM.
Example: Configure the switch to enable PIM-SSM, the group’s range is what is specified by access-list
23.
Switch (config)#ipv6 pim ssm range 23