PLANET XGS3-24040 - Manual (Page 324)

24-37
24.1.21 netbios-node-type
Command:
netbios-node-type {b-node | h-node | m-node | p-node | }
no netbios-node-type
Function:
Sets the node type for the specified port; the “no netbios-node-type” command cancels the
setting.
Parameters:
b-node stands for broadcasting node, h-node for hybrid node that broadcasts after point-to-point
communication;
m-node for hybrid node to communicate in point-to-point after broadcast; p-node for point-to-point
node;
is the node type in Hex from 0 to FF.
Default:
No client node type is specified by default.
Command Mode:
DHCP Address Pool Mode
Usage Guide:
If client node type is to be specified, it is recommended to set the client node type to h-node that
broadcasts after point-to-point communication.
Example:
Setting the node type for client of pool 1 to broadcasting node.
Switch(dhcp-1-config)#netbios-node-type b-node