PLANET XGS3-24040 - Manual (Page 780)

Commands for Security Function Chapter 6 Commands for TACACS+
46-1
Chapter 46 Commands for TACACS+
46.1 tacacs-server authentication host
Command: tacacs-server authentication host <ip-address> [port <port-number>] [timeout
] [key ] [primary]
no tacacs-server authentication host <ip-address>
Function: Configure the IP address, listening port number, the value of timeout timer and the key string
of the TACACS+ server; the no form of this command deletes TACACS+ authentication server.
Parameter: <ip-address> is the IP address of the server;<port-number> is the listening port number of
the server, the valid range is 0~65535, amongst 0 indicates it will not be an authentication server;
is the value of TACACS+ authentication timeout timer, shown in seconds and the valid range
is 1~60; key is the key string, containing maximum 16 characters; primary indicates it’s a
primary server.
Command Mode: Global Mode
Default: No TACACS+ authentication configured on the system by default.
Usage Guide: This command is for specifying the IP address, port number, timeout timer value and the
key string of the TACACS+ server used on authenticating with the switch. The parameter port is for
define an authentication port number which must be in accordance with the authentication port number of
specified TACACS+ server which is 49 by default. The parameters key and timeout is used to configure
the self-key and self-timeout, if the switch is not configure the timeout and key, it will
use the global value and key by command tacacs-server timeout and tacacs-server key
. This command can configure several TACACS+ servers communicate with the switch. The
configuration sequence will be used as authentication server sequence. And in case primary is
configured on one TACACS+ server, the server will be the primary server.
Example: Configure the TACACS+ authentication server address to 192.168.1.2, and use the global
configured key.
Switch(config)#tacacs-server authentication host 192.168.1.2
46.2 tacacs-server key
Command: tacacs-server key
no tacacs-server key
Function: Configure the key of TACACS+ authentication server; the “no tacacs-server key” command
deletes the TACACS+ server key.
Parameter: is the character string of the TACACS+ server key, containing maximum 16
characters.
Command Mode: Global Mode
Usage Guide: The key is used on encrypted packet communication between the switch and the
TACACS+ server. The configured key must be in accordance with the one on the TACACS+ server or
else no correct TACACS+ authentication will be performed. It is recommended to configure the
authentication server key to ensure the data security.