PLANET XGS3-24040 - Manual (Page 395)

29-108
Example:
Switch#config terminal
Switch(config)#route-map r1 permit 5
Switch(config-route-map)#set ip next-hop 10.2.2.2
29.22 set local-preference
Command:
set local-preference >
no set local-preference [>]
Function:
Configure the local priority of BGP route. The “no set local-preference [>]” command
deletes this configuration.
Parameter:
<pre_val > is the value of local priority, ranging between 0～4294967295.
Command Mode:
route-map mode
Usage Guide:
The local priority attribute is the priority level of a route. A route with a higher local priority level when
compared with other route of the same destination, will be more preferred than other route. The
local priority validates only within this AS and will not be transported to EBGP neighbors. To use this
command, one match clause should at first be defined.
Example:
Switch#config terminal
Switch(config)#route-map r1 permit 5
Switch(config-route-map)#set local-preference 60
29.23 set metric
Command:
set metric < metric_val>
no set metric [< metric_val>]
Function:
Configure the metric value of the route. The “no set metric [< metric_val>]” command deletes the
configuration.
Parameter:
<metric_val > is the metric value, ranging between 1～4294967295.
Command Mode:
route-map mode