PLANET XGS3-24040 - Manual (Page 770)

43-6
Command Mode: Admin and Configuration Mode.
Usage Guide: Use this command to display the number of dynamic ND of corresponding port and VLAN.
Examples: Display the number of dynamic ND of the port and VLAN which are configured with number
limitation function of ND.
Switch(config)# show nd-dynamic count interface ethernet 1/3
Port MaxCount CurrentCount
-----------------------------------------------------------------------------------------------------
Ethernet1/3 5 1
-----------------------------------------------------------------------------------------------------
Switch(config)# show nd-dynamic count vlan 1
Vlan MaxCount CurrentCount
-----------------------------------------------------------------------------------------------------
1 55 15
-----------------------------------------------------------------------------------------------------
43.11 debug switchport mac count
Command: debug switchport mac count
no debug switchport mac count
Function: When the number limitation function debug of MAC on the port, if the number of dynamic MAC
and the number of MAC on the port is larger than the max number allowed, users will see debug
information.” no debug switchport mac count” command is used to disable the number limitation
function debug of MAC on the port.
Parameters: None
Command Mode: Admin Mode
Default Settings: None
Usage Guide: Display the debug information of the number of dynamic MAC on the port.
Examples:
Switch#debug switchport mac count
%Jun 14 16:04:40 2007 Current mac count 21 is more than or equal to the maximum limit in
port Ethernet1/1
!!%Jun 14 16:04:40 2007 Mac learning will be stopped and some mac will be delete !!
43.12 debug switchport arp count
Command: debug switchport arp count
no debug switchport arp count
Function: When the number limitation function debug of ARP on the port, if the number of dynamic ARP
and the number of ARP on the port is larger than the max number allowed, users will see debug
information.” no debug switchport arp count” command is used to disable the number limitation
function debug of ARP on the port.
Parameters: None
Command Mode: Admin Mode