PLANET XGS3-24040 - Manual (Page 709)

XGS3 Command Guide
39-41
Example:
switch(config)#ipv6 multicast destination-control 1 00-01-03-05-07-09 access-group 9000
39.6.6 ipv6 multicast policy
Command: ipv6 multicast policy > cos <priority>
no ipv6 multicast policy <IPADDRSRC/M> > cos
Function: Configure IPv6 policy multicast, the no operation of this command is to cancel the policy
multicast of IPv6.
Parameters: : The source address and the length of the mask of IPv6 multicast.
: The multicast address of IPv6 and the length of mask of multicast
address
: The specified priority, the range of which is <0-7>.
Default: Not configured.
Command Mode: Global Configuration Mode.
Usage Guide: Using this command to configure can change the priority of the multicast data which is
confined by the act of matching of this switch to a specified value, and set the TOS to the same value
simultaneously. Please pay attention to that, for the messages sent in UNTAG mode, their priority will not
be changed.
Example:
Switch(config)#ipv6 multicast policy 2008::1/64 ff1e::3/64 cos 4
39.6.7 ipv6 multicast source-control
Command: ipv6 multicast source-control
no ipv6 multicast source-control
Function: Configure to globally enable IPv6 multicast source control, the no operation of this command
is to recover and globally disable the IPv6 multicast source control.
Parameters: None.
Default: Disabled.
Command Mode: Global Configuration Mode.
Usage Guide: Only when the IPv6 multicast source control is enabled globally, the source control access
list can be applied to ports. After configuring this command, the IPv6 multicast data received by all the
ports will be dropped by the switch if there is no matched multicast source control entry, that it only the
multicast data matched as PERMIT can be received and forwarded.
Example:
Switch(config)#ipv6 multicast source-control
39.6.8 ipv6 multicast source-control access-group
Command: ipv6 multicast source-control access-group <8000-8099>
no ipv6 multicast source-control access-group <8000-8099>