PLANET XGS3-24040 - Manual (Page 644)

XGS3 Command Guide
38-73
02:17:38:58: IGMP: Received membership query on dvmrp2 from 192.168.1.11 for 0.0
.0.0
02:17:39:26: IGMP: Send membership query on vlan1 for 0.0.0.0
02:17:39:26: IGMP: Received membership query on dvmrp2 from 192.168.1.11 for 0.0
.0.0
38.9.4 ip igmp access-group
Command: ip igmp access-group {<acl_num | acl_name>}
no ip igmp access-group
Function: Configure interface to filter IGMP group; the “no ip igmp access-group” command cancels
the filter condition
Parameter: {} is SN or name of access-list, value range of acl_num is from 1 to
99.
Default: Default no filter condition
Command Mode: Interface Configuration Mode
Usage Guide: Configure interface to filter groups, permit or deny some group joining.
Example: Configure interface vlan1 to permit group 224.1.1.1, deny group 224.1.1.2.
Switch (config)#access-list 1 permit 224.1.1.1 0.0.0.0
Switch (config)#access-list 1 deny 224.1.1.2 0.0.0.0
Switch (config)#interface vlan 1
Switch(Config-if-Vlan1)#ip igmp access-group 1
38.9.5 ip igmp immediate-leave
Command: ip igmp immediate-leave group-list {|}
no ip igmp immediate-leave
Function: Configure IGMP working in immediate-leave mode, that is, when the host transmits member
identity report of equivalent to leave a group, router does not transmit query, it directly confirms there is
no member of this group in subnet; the “no ip igmp immediate-leave” command cancels
immediate-leave mode.
Parameter: is access-list SN, value is from 1 to 99.
is access-list name.
Default: Interface default and no immediate-leave group of configuration after finished product
Command Mode: Interface Configuration Mode
Usage Guide: The command only can apply in only one host condition in subnet.
Example: Configure immediate-leave mode on access-group list 1
Switch (Config-if-Vlan1)#ip igmp immediate-leave group-list 1