PLANET XGS3-24040 - Manual (Page 732)

Commands for Security Function Chapter 2 Commands for 802.1x
41-4
access-list of this coded numeric extended does not exist, thus to create such a access-list.
Parameters: is the No. of access-list, 100-299; <protocol> is the No. of upper-layer protocol
of ip, 0-255; is the source IP address, the format is dotted decimal notation; <sMask > is the
reverse mask of source IP, the format is dotted decimal notation; is the destination IP address,
the format is dotted decimal notation; <dMask> is the reverse mask of destination IP, the format is dotted
decimal notation, attentive position o, ignored position1;<igmp-type>,the type of igmp, 0-15;
, the type of icmp, 0-255;, protocol No. of icmp, 0-255;, IP priority, 0-7;
, to value, 0-15; , source port No., 0-65535; , the down boundary of source
port; , the up boundary of source port; , the down boundary of destination port;
, the up boundary of destination port; , destination port No., 0-65535;
, the name of time-range.
Command Mode: Global mode
Default: No access-lists configured.
Usage Guide: When the user assign specific for the first time, ACL of the serial number is
created, then the lists are added into this ACL; the access list which marked 200-299 can configure not
continual reverse mask of IP address.
<igmp-type> represent the type of IGMP packet, and usual values please refer to the following
description:
17(0x11): IGMP QUERY packet
18(0x12): IGMP V1 REPORT packet
22(0x16): IGMP V2 REPORT packet
23(0x17): IGMP V2 LEAVE packet
34(0x22): IGMP V3 REPORT packet
19(0x13): DVMR packet
20(0x14): PIM V1 packet
Particular notice: The packet types included here are not the types excluding IP OPTION. Normally,
IGMP packet contains OPTION fields, and such configuration is of no use for this type of packet. If you
want to configure the packets containing OPTION, please directly use the manner where OFFSET is
configured.
Examples: Create the numeric extended access-list whose serial No. is 110. deny icmp packet to pass,
and permit udp packet with destination address 192. 168. 0. 1 and destination port 32 to pass.
Switch(config)#access-list 110 deny icmp any any-destination
Switch(config)#access-list 110 permit udp any host-destination 192.168.0.1 d-port 32
41.4 access-list (ip standard)
Command: access-list {deny | permit} {{ <sMask >} | any-source| {host-source
}}
no access-list
Functions: Create a numeric standard IP access-list. If this access-list exists, then add a rule list; the “no
access-list “operation of this command is to delete a numeric standard IP access-list.
Parameters: is the No. of access-list, 100-199; is the source IP address, the format
is dotted decimal notation; <sMask > is the reverse mask of source IP, the format is dotted decimal