PLANET XGS3-24040 - Manual (Page 138)

8-4
Parameters:
<seconds>is the time interval, ranging from 1 to 8192 seconds.
Default:
The interval is 2 seconds by default.
Command Mode:
Global Mode.
Usage Guide:
When the messages are being sent continuously, a sending delay is set to prevent the Remote
information from being updated repeatedly due to sending messages simultaneously.
Example:
Set the delay of sending messages as 3 seconds.
Switch(config)# lldp transmit delay 3
8.7 lldp notification interval
Command:
lldp notification interval <seconds>
no lldp notification interval
Function:
When the time interval ends, the system is set to check whether the Remote Table has been
changed. If it has, the system will send Trap to the SNMP management end.
Parameters:
<seconds>is the time interval, ranging from 5 to 3600 seconds.
Default:
The time interval is 5 seconds.
Command Mode:
Global Mode.
Usage Guide:
After configuring the notification time interval, a “trap” message will be sent at the end of this time
interval whenever the Remote Table changes.
Example:
Set the time interval of sending Trap messages as 20 seconds.
Switch(config)# lldp notification interval 20
8.8 lldp trap
Command:
lldp trap <enable|disable>
Function:
enable: configure to enable the Trap function on the specified port;
disable: configure to disable the Trap function on the specified port.
Parameters:
None.