PLANET XGS3-24040 - Manual (Page 443)

32-156
32.16 redistribute ospf
Command:
redistribute ospf [<process-tag>] [metric<value>] [route-map<word>]
no redistribute ospf [<process-tag>]
Function:
To redistribute routing information from external OSPFv3 processes to RIPng process. The no form
of this command will remove the introduced OSPFv3 routing entries.
Parameters:
process-tag is the string tag for OSPFv3 process with maximum length limited within 15 characters.
If not specified, the default process will be used.
metric<value> is the metric for the introduced routing entries, limited between 0 and 16.
route-map<word> is the pointer to the introduced routing map.
Default:
Not redistributed by default.
Command Mode:
RIPng Configuration Mode.
Usage Guide:
None.
Example:
To redistribute OSPFv3 ABC routing ro RIPng.
Switch(config)#router ipv6 rip
Switch (config-router)#redistribute ospf abc
32.17 route
Command:
route <ipv6-address>
no route <ipv6-address>
Function:
This command configures a static RIPng route. The “no route <ipv6-address>“ command deletes
this route.
Parameter:
Specifies this destination IPv6 address prefix and its length show in colon hex notation.
Usage Guide:
The command adds a static RIPng route, and is mainly used for debugging. Routes configured by
this command will not appear in kernel route table but in the RIPng route database, however it could
be located by using the show ipv6 rip command.
Command Mode:
Router mode
Example:
Switch#config terminal