PLANET XGS3-24040 - Manual (Page 413)

31-126
Parameter:
is the name or access-list number to be applied.
is the name of the prefix-list to be applied.
specifies the name of interface to be applied with route filtering.
Default:
The function in default situation is disabled.
Command Mode:
Router mode and address-family mode
Usage Guide:
The filter will be applied to all the interfaces in case no specific interface is set.
Example:
Switch# config terminal
Switch(config)# router rip
Switch(config-router)# distribute-list prefix myfilter in vlan 1
31.11 exit-address-family
Command:
exit-address-family
Function:
Exit address-family mode
Command Mode:
address-family mode
Example:
Switch(config)# router rip
Switch(config-router)# address-family ipv4 vrf IPI
Switch(config-router-af)# exit-address-family
Switch(config-router)#
31.12 ip rip aggregate-address
Command:
ip rip aggregate-address A.B.C.D/M
no ip rip aggregate-address A.B.C.D/M
Function:
To configure RIP aggregation route. The no form of this command will delete this configuration.