PLANET XGS3-24040 - Manual (Page 805)

Commands for Reliability Content
53-1
Chapter 53 Commands for sFlow
53.1 sflow destination
Command: sflow destination <collector-address> [<collector-port>]
no sflow destination
Function: Configure the IP address and port number of the host on which the sFlow analysis software is
installed. If the port has been configured with IP address, the port configuration will be applied, or else the
global configuration will be applied. The “no” form of this command restores the port to default and
deletes the IP address.
Parameter: is the IP address of the analyzer, shown in dotted decimal notation.
<collector-port> is the destination port of the sent sFlow packets.
Command Mode: Global Mode and Port Mode.
Default: The destination port of the sFlow packet is defaulted at 6343, and the analyzer has no default
address.
Usage Guide: If the analyzer address is configured at Port Mode, this IP address and port configured at
Port Mode will be applied when sending the sample packet. Or else the address and port configured at
global mode will be applied. The analyzer address should be configured to let the sFlow sample proxy
work properly.
Example: Configure the analyzer address and port at global mode.
switch (config)#sflow destination 192.168.1.200 1025
53.2 sflow agent-address
Command: sflow agent-address <agent-address>
no sflow agent-address
Function: Configure the sFlow sample proxy address. The “no” form of this command deletes the proxy
address.
Parameter: is the sample proxy IP address which is shown in dotted decimal
notation.
Command Mode: Global Mode.
Default: None default value.
Usage Guide: The proxy address is used to mark the sample proxy which is similar to OSPF or the
Router ID in the BGP. However it is not necessary to make the sFlow sample proxy work properly.
Example: Sample the proxy address at global mode.
switch (config)#sflow agent-address 192.168.1.200
53.3 sflow priority
Command: sflow priority <priority-value>
no sflow priority
Function: Configure the priority when sFlow receives packet from the hardware. The "no” form of the
command restores to the default.
Parameter: is the priority value with a valid range of 0-3.