PLANET XGS3-24040 - Manual (Page 386)

29-99
Example:
Switch#config terminal
Switch(config)#route-map r1 permit 5
Switch(config-route-map)#match community 100 exact-match
29.6 match interface
Command:
match interface <interface-name >
no match interface [<interface-name >]
Function:
Configure to match the interfaces. The “no match interface [<interface-name >]“deletes this
configuration.
Parameter:
“<interface-name >“is the name of the interface.
Command Mode:
route-map mode
Usage Guide:
This command matches according to the next-hop messages in the route. If the matching
succeeded, then the “permit” or “deny” action in the route-map is performed. This command is only
used in RIP and OSPF protocols.
Example:
Switch#config terminal
Switch(config)#route-map r1 permit 5
Switch(config-route-map)#match interface vlan1
29.7 match ip
Command:
match ip
no match ip
Function:
Configure the routing prefix or next-hop. The “no match ip <address | next-hop> [<ip-acl -name |
ip-acl -num | prefix-list list-name>]” deletes this configuration.
Parameter:
<ip-acl -name > is the name of ip access-list, <ip-acl -num > is the ip access-list sequence number,
ranging between 1～199 or 1300～2699（extension scope）, prefix-list means the matching should
follow the prefix-list rules, list-name is the name of prefix-list.